Introduction to the manual operation of concrete mixing plant.

Introduction to the manual operation of concrete mixing plant.
You can operate concrete plant automatically or manually.if operators are occupied by other issues the automatic operating system is always available for them. Though there are always a option of automation but as a professional operator, there are also some basic knowledge about manually operating you might want to learn. The following content will teach you how to operate a concrete plant properly.
The procedure
Connect to the electricity>turn it on>switch to manual mode>switch the host and air compressor to 0.7MPA>turn on the IPC and then warm it up for 20 minutes>select the recipe you need>press the button to start mixing>the mixture is unloaded to the silo>When the hopper door is closed, please stop the discharging> Mixing is finished >The concrete is discharging from the host door >Press the host to shut down.
The Specific Manual Operation Process of Concrete Mixing Plant
The first step is to close the circuit breaker. The second step is to turn on the control power switch on the console. The third step is to start the air compressor. When the pressure of air compressor reaches above 0.4Mpa, press the start button of hybrid host to start host motor of the hybrid. The fourth step is to press start button of the belt conveyor to start the belt conveyor when the motor of hybrid host is completed. The fifth step is to start the belt conveyor to make the belt conveyor automatically starts and runs. The sixth step is to set the manual batch weighing value through the weighing display panel or the keyboard. The seventh step is to press the manual batch button if needed.
Pay More Attention to the Manual Operation in Stationary or mobile concrete batch plant for sale
During manual operation, if cement is not used, please set it to zero in the ratio setting.
During manual measurement, please operate it in the order of “Cement 1 > Cement 2 > Cement discharge > Cement stop”.
If the cement ratio is not set to zero, please not skip the appropriate button to not use the cement, as this will seriously affect the measurement accuracy of the cement.

Get Support Or Price